It happens occasionally that your car makes noises from your brakes, you are certainly not reassured by this sorts of noise and you instantly tend to think that you will have an accident or that the repair will cost you an astronomical sum. So, what if you detect noise from the brake on your Mazda 2? It may not be anything major and you may have the capability to repair it yourself, but when in doubt, as with such problem your safety and the one from other is in question, it is better to check before a more serious failure happens. It’s with idea in mind that we have decided to write this content and give you the chance to find the problem and find a solution. We will go through different steps, review all possible sources of brake noise on Mazda 2, and give you the causes for them in order to assist you fix the problem.
The different types of brake noise Mazda 2 and their origins
The objective of the Mazda 2 brakes is to come slow down and stop your vehicule. This component is an important part of your vehicule’s safety. Discovering a sound from it must therefore be investigated immediately and leaving it lying around is not a good alternative.
I perceive a grinding noise on my brake Mazda 2
If you listen to a grinding or scrap metal noise coming from the brake of your Mazda 2, it is highly imaginable that it will be caused by brake pads at the end of their life, actually, the purpose of the pads is to act as a buffer during braking and they will therefore logically wear out after some time. Each producer gives an average runtime in kilometres for pads, but depending on your driving style and route, this may fluctuate. Remove the wheels in question and check the wear indicator on them. If they are dead, they must be swapped quickly as they will promptly damage your discs and keep doing this scrap or grinding noise on Mazda 2. If after checking out this point, you’re still experiencing a grinding noise on your Mazda 2, have a look at this article to find a solution.
I experience a continuous noise that stops when I brake with my Mazda 2
If you are the victim of a constant noise from the brakes Mazda 2 that only ceases when you press your brake system, it is quite plausible that caliper wear is the cause. In fact, they can jam after some time, especially if they are not used enough. In this case, they will tend to remain in the closed position, so they will always stick the pads against the discs, which will lead to an increase in consumption and premature deterioration of your pads. To confirm it, try to brake many times frankly to try to unblock them. If this does not work, it will be necessary to consider replacing them.
I experience vibration when I brake with my Mazda 2
If in your case, you experience a vibration when braking that would have come from the brake your Mazda 2, you will have to feel concerned about the state of your discs. Discs tend to wear over time and although they have a longer runtime than pads, they must be replaced at some point. A vibration most often informs of veiled brake disc, you can check it by removing your wheels. If so, change them or have them replaced by your auto technician.
I encounter a squealing noise when I brake with my Mazda 2
Finally, if you have a noise close to a squeak when you use your brakes, it is possible that brake pad dust has settled in the brake calipers of your Mazda 2, creating a squeak when the system is pressurized. You will have to take it out your wheels and clean the calipers with a snowblower and a brush (metal or rigid).
