If you find a noise on your car, you are right to be attentive of it and take it seriously, although it is conceivable that nothing critical will happen, it is also conceivable that it is the symptom of a more significant fix. A noise that happens in the trunk of your Bmw Serie 6 is fortunately more a sign of a small manipulation or service, rather than a complicated one. To support you in your research, we have decided to produce this content to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Bmw Serie 6 can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Bmw Serie 6 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Bmw Serie 6 generated by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this scenario, open the trunk of your Bmw Serie 6, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Bmw Serie 6 that is relating to other origins such as shock absorbers, do not hesitate to consult this content on the noises at the back of a Bmw Serie 6.
Noise in the trunk of my Bmw Serie 6 : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that became loose. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your Bmw Serie 6 is very frequently relating to this trouble. Some solutions are existing to you according to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is good enough to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Make sure to check the centering of the striker in connection with the trunk lock. If after looking at the trunk of your Bmw Serie 6 closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Bmw Serie 6 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell behind your plate. In fact, when a plate change is done, to remove the old one the process used is to drill the existing rivets to be able to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Bmw Serie 6 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic situation, you will have to remove the bumper to remove the bits of rivet that are running around.
