It is never pleasurable to discover a noise from your car you don’t know where from. Then what if you detect a serpentine belt noise that stays on your Mitsubishi Lancer? It is highly conceivable that this is a insignificant issue, but before being sure, it is better to accomplish some checks. If this belt noise comes from your serpentine or driving belt, our team has written a post to help you finding and repairing it. First, we will look at the serpentine belt noises on your Mitsubishi Lancer and then we will check out the origins of these sounds.
I encounter noises from serpentine belt Mitsubishi Lancer
The best strategy to control the state of your belts is to listen to your vehicle. Immediately after you find sounds such as squealing or bells, you should take a closer look to check their source. The job of the serpentine belt or driving belt of your Mitsubishi Lancer is to transfer the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal use of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.
I discover squealing noises on my serpentine belt Mitsubishi Lancer
This sort of squealing belt noises on Mitsubishi Lancer, which will often be acute, can in most cases appear when the engine is cold, or when the acceleration increases in intensity. . This sort of sound must be significant and it is normally quite simple to relate it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being visible, it should not be too complicated for you to point a belt noise on your Mitsubishi Lancer. The cause of this issue can be in connection with the damper pulley, which operates as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the opportunity that this phenomenon is annodine. As the serpentine belt of your Mitsubishi Lancer is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to check the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I discover loud serpentine or driving belt noises Mitsubishi Lancer
Just like squealing, a driving belt noise on your Mitsubishi Lancer that sounds like a loud grinding sound can say a lot about its state. It is therefore imperative that you look further and find the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Make sure you check first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to replace the tensioner or pulley.
I discover bearing noises on the serpentine belt of my Mitsubishi Lancer
Finally, if in your case you identify a bearing belt noise on Mitsubishi Lancer, it is conceivable that it is in connection with a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Mitsubishi Lancer which could maybe help you.
