It is never enjoyable to find out a noise from your car you don’t know where from. So what if you notice a serpentine belt noise that persists on your Dodge Challenger? It is highly plausible that this is a minimal trouble, but before being sure, it is better to accomplish some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a page to support you finding and solving it. First, we will look at the serpentine belt noises on your Dodge Challenger and then we will take a look at the origins of these sounds.
I encounter noises from serpentine belt Dodge Challenger
The best technique to control the state of your belts is to listen to your car. As soon as you perceive sounds such as squealing or bells, you should take a closer look to examine their source. The job of the serpentine belt or driving belt of your Dodge Challenger is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal overall performance of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.
I find out squealing noises on my serpentine belt Dodge Challenger
This sort of squealing belt noises on Dodge Challenger, which will often be acute, can in most cases happen when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be heavy and it is obviously quite simple to link it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being accessible, it should not be too difficult for you to spot a belt noise on your Dodge Challenger. The reason of this trouble can be related to the damper pulley, which operates as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this event is annodine. As the serpentine belt of your Dodge Challenger is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to examine the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Dodge Challenger
Just like squealing, a driving belt noise on your Dodge Challenger that sounds like a loud grinding sound can reveal a lot about its state. It is therefore important that you look further and locate the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Remember to examine first the serpentine/driving belt which in most cases is the reason of this trouble, otherwise it will be necessary to replace the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Dodge Challenger
Finally, if in your case you recognize a bearing belt noise on Dodge Challenger, it is plausible that it is related to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses alternatives, you still perceive a belt noises, read our article about timing belt noises on Dodge Challenger which could maybe help you.
