If you notice a noise on your vehicle, you are right to be concerned of it and take it seriously, although it is plausible that nothing significant will results, it is also plausible that it is the signal of a more critical fix. A noise that shows up in the trunk of your Cadillac Escalade is luckily more a signal of a small correction or restoration, rather than a difficult one. To support you in your research, we have chosen to produce this article to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Cadillac Escalade can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Cadillac Escalade : Built up dirt that triggers poor closing
>
We will therefore start with a trunk noise on your Cadillac Escalade created by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt collects at the trunk gasket. This trouble triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Cadillac Escalade, examine the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Cadillac Escalade that is relating to other sources such as shock absorbers, do not hesitate to read this article on the noises at the back of a Cadillac Escalade.
Noise in the trunk of my Cadillac Escalade : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that became loose. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your Cadillac Escalade is very often relating to this trouble. Several solutions are existing to you subject to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is sufficient to solve the problem. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take out the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Remember to examine the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Cadillac Escalade closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Cadillac Escalade : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell behind your plate. In fact, when a plate replacement is made, to take out the old one the technique used is to drill the existing rivets to be able to release the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Cadillac Escalade linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to identify the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic situation, you will have to take out the bumper to remove the bits of rivet that are running around.
