If you find out a noise on your vehicle, you are right to be concerned of it and take it seriously, although it is possible that nothing serious will happen, it is also possible that it is the symptom of a more significant repair. A noise that occurs in the trunk of your Chevrolet Cruze is thankfully more a sign of a small correction or repair, rather than a difficult one. To help you in your research, we have decided to produce this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Chevrolet Cruze can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Chevrolet Cruze : Accumulated dirt that triggers poor closing
We will therefore begin with a trunk noise on your Chevrolet Cruze caused by dirt accumulated on your joints, lock for example. In fact, it is possible that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Chevrolet Cruze, examine the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Chevrolet Cruze that is related to other origins such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a Chevrolet Cruze.
Noise in the trunk of my Chevrolet Cruze : Loose lock, clicking noise
Second possibility, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your Chevrolet Cruze is very frequently related to this issue. Different solutions are available to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is enough to eliminate the trouble. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. You should examine the centering of the striker in relation to the trunk lock. If after examining the trunk of your Chevrolet Cruze closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk Chevrolet Cruze : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. In fact, when a plate change is made, to take off the old one the procedure used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Chevrolet Cruze linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to discern the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to take off the bumper to remove the bits of rivet that are running around.