If you find out a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will results, it is also conceivable that it is the signal of a more critical restoration. A noise that shows up in the trunk of your Toyota Rav 4 is thankfully more a sign of a small manipulation or repair, rather than a complex one. To support you in your research, we have decided to compose this content page to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Toyota Rav 4 can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota Rav 4 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Toyota Rav 4 induced by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your Toyota Rav 4, check the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota Rav 4 that is connected to other origins such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Toyota Rav 4.
Noise in the trunk of my Toyota Rav 4 : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that has taken up some play. And this is one of the most probably possibilities. In fact, knowing a trunk noise on your Toyota Rav 4 is very often connected to this trouble. Some solutions are available to you according to the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Be sure you verify the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Toyota Rav 4 closes badly, it means that you have moved it too far, replicate the procedure by pushing the striker less.
Noise in my trunk Toyota Rav 4 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate change is made, to take off the old one the process used is to drill the existing rivets in order to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota Rav 4 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to define the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic case, you will have to take off the bumper to remove the bits of rivet that are running around.
