If you identify a noise on your automobile, you are right to be careful of it and take it seriously, although it is conceivable that nothing critical will occur, it is also conceivable that it is the symptom of a more critical repair. A noise that appears in the trunk of your Peugeot Expert Tepee is luckily more a signal of a small correction or fix, rather than a complex one. To help you in your research, we have decided to generate this content to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Peugeot Expert Tepee can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Peugeot Expert Tepee : Built up dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Peugeot Expert Tepee induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This trouble triggers a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your Peugeot Expert Tepee, verify the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Peugeot Expert Tepee that is linked to other origins such as shock absorbers, do not hesitate to read this content on the noises at the back of a Peugeot Expert Tepee.
Noise in the trunk of my Peugeot Expert Tepee : Loose lock, clicking noise
Second probability, you may also, over time, be the victim of a locking system that has taken up some play. And this is one of the most potential alternatives. Indeed, knowing a trunk noise on your Peugeot Expert Tepee is very frequently linked to this trouble. Some solutions are existing to you depending on the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the system with thick grease is more than enough to fix the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in regards to the trunk lock. If after looking at the trunk of your Peugeot Expert Tepee closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Peugeot Expert Tepee : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell at the rear of your plate. Indeed, when a plate change is done, to remove the old one the procedure used is to drill the existing rivets to be able to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Peugeot Expert Tepee linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to discern the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant situation, you will have to remove the bumper to remove the bits of rivet that are running around.
