If you pay attention to a noise on your vehicle, you are right to be careful of it and take it seriously, although it is conceivable that nothing significant will occur, it is also conceivable that it is the signal of a more critical fix. A noise that occurs in the trunk of your Jeep Cherokee is thankfully more a signal of a small correction or fix, rather than a complex one. To help you in your research, we have chosen to generate this article to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Jeep Cherokee can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Jeep Cherokee : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Jeep Cherokee caused by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Jeep Cherokee, verify the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Jeep Cherokee that is linked to other sources such as shock absorbers, do not hesitate to have a look to this article on the noises at the back of a Jeep Cherokee.
Noise in the trunk of my Jeep Cherokee : Loose lock, clicking noise
Second probability, you may also, over time, be the victim of a locking system that has taken up some play. And this is one of the most probably possibilities. In fact, knowing a trunk noise on your Jeep Cherokee is very often linked to this issue. Some solutions are available to you depending on the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the system with thick grease is enough to eliminate the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to remove the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Remember to verify the centering of the striker in regards to the trunk lock. If after checking the trunk of your Jeep Cherokee closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Jeep Cherokee : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell behind your plate. In fact, when a plate swap is done, to remove the old one the procedure used is to drill the existing rivets in order to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Jeep Cherokee linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to identify the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to remove the bumper to remove the bits of rivet that are running around.
