If you find a noise on your vehicle, you are right to be attentive of it and take it seriously, although it is conceivable that nothing major will occur, it is also conceivable that it is the indication of a more critical restoration. A noise that appears in the trunk of your Hyundai Ix35 is luckily more a indicator of a small correction or service, rather than a difficult one. To help you in your research, we have chosen to generate this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Hyundai Ix35 can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Hyundai Ix35 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your Hyundai Ix35 induced by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this scenario, open the trunk of your Hyundai Ix35, examine the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Hyundai Ix35 that is linked to other origins such as shock absorbers, do not hesitate to have a look to this content page on the noises at the back of a Hyundai Ix35.
Noise in the trunk of my Hyundai Ix35 : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most probably alternatives. In fact, knowing a trunk noise on your Hyundai Ix35 is very often linked to this issue. Different solutions are existing to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the mechanism with thick grease is enough to solve the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Be sure you verify the centering of the striker in regards to the trunk lock. If after looking at the trunk of your Hyundai Ix35 closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Hyundai Ix35 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. In fact, when a plate swap is made, to remove the old one the strategy used is to drill the existing rivets in order to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Hyundai Ix35 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to discern the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic case, you will have to remove the bumper to remove the bits of rivet that are running around.
