If you acknowledge a noise on your car, you are right to be concerned of it and take it seriously, although it is conceivable that nothing major will happen, it is also conceivable that it is the symptom of a more significant repair. A noise that occurs in the trunk of your Honda Insight is fortunately more a indicator of a small manipulation or fix, rather than a difficult one. To support you in your research, we have chosen to produce this content page to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Honda Insight can come from built up dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Honda Insight : Accumulated dirt that causes poor closing
>
We will therefore start with a trunk noise on your Honda Insight induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this scenario, open the trunk of your Honda Insight, check the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Honda Insight that is relating to other origins such as shock absorbers, do not hesitate to have a look to this content page on the noises at the back of a Honda Insight.
Noise in the trunk of my Honda Insight : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that became loose. And this is one of the most potential possibilities. Indeed, knowing a trunk noise on your Honda Insight is very frequently relating to this trouble. Some solutions are existing to you depending on the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is appropriate to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to remove the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Don’t forget to check the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Honda Insight closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Honda Insight : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell at the rear of your plate. Indeed, when a plate swap is made, to take off the old one the strategy used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Honda Insight linked to a rivet, you will need to check that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take off the bumper to remove the bits of rivet that are running around.
