If you pay attention to a noise on your automobile, you are right to be concerned of it and take it seriously, although it is conceivable that nothing major will results, it is also conceivable that it is the signal of a more important restoration. A noise that shows up in the trunk of your Ford S-max 2 is luckily more a indication of a small manipulation or fix, rather than a complicated one. To help you in your research, we have decided to generate this content to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Ford S-max 2 can come from built up dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Ford S-max 2 : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Ford S-max 2 caused by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this situation, open the trunk of your Ford S-max 2, check the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Ford S-max 2 that is connected to other origins such as shock absorbers, do not hesitate to have a look to this content on the noises at the back of a Ford S-max 2.
Noise in the trunk of my Ford S-max 2 : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that became loose. And this is one of the most likely possibilities. Indeed, knowing a trunk noise on your Ford S-max 2 is very frequently connected to this trouble. Several solutions are available to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is more than enough to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to remove the cover that will allow access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in connection with the trunk lock. If after looking at the trunk of your Ford S-max 2 closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk Ford S-max 2 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell behind your plate. Indeed, when a plate replacement is made, to take off the old one the strategy used is to drill the existing rivets in order to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Ford S-max 2 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to identify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic situation, you will have to take off the bumper to remove the bits of rivet that are running around.
