If you acknowledge a noise on your automobile, you are right to be aware of it and take it seriously, although it is conceivable that nothing critical will result, it is also conceivable that it is the sign of a more significant fix. A noise that appears in the trunk of your Fiat Panda 2 is luckily more a indication of a small correction or service, rather than a complicated one. To support you in your research, we have decided to generate this article to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Fiat Panda 2 can come from accumulated dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Fiat Panda 2 : Accumulated dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Fiat Panda 2 induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt collects at the trunk gasket. This problem triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this circumstance, open the trunk of your Fiat Panda 2, check the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Fiat Panda 2 that is relating to other sources such as shock absorbers, do not hesitate to have a look to this article on the noises at the back of a Fiat Panda 2.
Noise in the trunk of my Fiat Panda 2 : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that became loose. And this is one of the most probably possibilities. Indeed, knowing a trunk noise on your Fiat Panda 2 is very frequently relating to this problem. Different solutions are existing to you depending on the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is sufficient to fix the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to remove the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Don’t forget to examine the centering of the striker in relation to the trunk lock. If after looking at the trunk of your Fiat Panda 2 closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Fiat Panda 2 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. Indeed, when a plate swap is made, to remove the old one the process used is to drill the existing rivets in order to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Fiat Panda 2 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
