If you detect a noise on your automobile, you are right to be concerned of it and take it seriously, although it is plausible that nothing critical will results, it is also plausible that it is the sign of a more critical repair. A noise that comes out in the trunk of your Fiat Bravo 2 is fortunately more a sign of a small correction or repair, rather than a complex one. To help you in your research, we have decided to compose this content to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Fiat Bravo 2 can come from accumulated dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Fiat Bravo 2 : Accumulated dirt that triggers poor closing
>
We will therefore start with a trunk noise on your Fiat Bravo 2 triggered by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a automobile that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem triggers a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this circumstance, open the trunk of your Fiat Bravo 2, examine the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Fiat Bravo 2 that is related to other sources such as shock absorbers, do not hesitate to read this content on the noises at the back of a Fiat Bravo 2.
Noise in the trunk of my Fiat Bravo 2 : Loose lock, clicking noise
Second possibility, you may also, over time, be the victim of a locking system that became loose. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Fiat Bravo 2 is very frequently related to this problem. Several solutions are available to you depending on the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is enough to solve the issue. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to remove the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to check the centering of the striker in relation to the trunk lock. If after examining the trunk of your Fiat Bravo 2 closes badly, it means that you have moved it too far, duplicate the operation by pushing the striker less.
Noise in my trunk Fiat Bravo 2 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell behind your plate. In fact, when a plate swap is made, to remove the old one the process used is to drill the existing rivets to be able to release the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Fiat Bravo 2 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
