If you find a noise on your automobile, you are right to be aware of it and take it seriously, although it is conceivable that nothing serious will results, it is also conceivable that it is the symptom of a more important fix. A noise that comes out in the trunk of your Cadillac CT6 is fortunately more a sign of a small manipulation or fix, rather than a complicated one. To help you in your research, we have decided to generate this article to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Cadillac CT6 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Cadillac CT6 : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Cadillac CT6 generated by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this situation, open the trunk of your Cadillac CT6, check the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Cadillac CT6 that is related to other origins such as shock absorbers, do not hesitate to have a look to this article on the noises at the back of a Cadillac CT6.
Noise in the trunk of my Cadillac CT6 : Loose lock, clicking noise
Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most probably alternatives. Indeed, knowing a trunk noise on your Cadillac CT6 is very frequently related to this issue. Different solutions are available to you subject to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is sufficient to resolve the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Be sure you examine the centering of the striker in connection with the trunk lock. If after checking out the trunk of your Cadillac CT6 closes badly, it means that you have moved it too far, duplicate the process by pushing the striker less.
Noise in my trunk Cadillac CT6 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell at the rear of your plate. Indeed, when a plate swap is made, to take out the old one the process used is to drill the existing rivets to be able to release the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Cadillac CT6 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to take out the bumper to remove the bits of rivet that are running around.
