If you notice a noise on your automobile, you are right to be aware of it and take it seriously, although it is possible that nothing critical will happen, it is also possible that it is the sign of a more significant restoration. A noise that occurs in the trunk of your Lincoln Continental is fortunately more a indication of a small manipulation or repair, rather than a complicated one. To support you in your research, we have chosen to write this content page to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Lincoln Continental can come from built up dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-lincoln-continental

Noise in the trunk Lincoln Continental : Accumulated dirt that triggers poor closing

>
We will therefore start with a trunk noise on your Lincoln Continental triggered by dirt accumulated on your joints, lock for example. Indeed, it is possible that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt collects at the trunk gasket. This problem triggers a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your Lincoln Continental, check the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Lincoln Continental that is related to other sources such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a Lincoln Continental.

Noise in the trunk of my Lincoln Continental : Loose lock, clicking noise

Second probability, you may also, over time, encounter a locking system that has taken up some play. And this is one of the most potential possibilities. Indeed, knowing a trunk noise on your Lincoln Continental is very often related to this problem. Different solutions are available to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is more than enough to fix the trouble. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to verify the centering of the striker in connection with the trunk lock. If after examining the trunk of your Lincoln Continental closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.

Noise in my trunk Lincoln Continental : Rivet following plate change in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell backside your plate. Indeed, when a plate replacement is done, to remove the old one the process used is to drill the existing rivets to be able to released the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Lincoln Continental linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing case, you will have to remove the bumper to remove the bits of rivet that are running around.