If you pay attention to a noise on your car, you are right to be aware of it and take it seriously, although it is plausible that nothing critical will occur, it is also plausible that it is the signal of a more important repair. A noise that occurs in the trunk of your Bmw Serie 2 F22 is fortunately more a indicator of a small adjustment or fix, rather than a complicated one. To help you in your research, we have chosen to generate this article to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Bmw Serie 2 F22 can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Bmw Serie 2 F22 : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Bmw Serie 2 F22 created by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a car that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this situation, open the trunk of your Bmw Serie 2 F22, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Bmw Serie 2 F22 that is related to other origins such as shock absorbers, do not hesitate to consult this article on the noises at the back of a Bmw Serie 2 F22.
Noise in the trunk of my Bmw Serie 2 F22 : Loose lock, clicking noise
Second probability, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Bmw Serie 2 F22 is very frequently related to this trouble. Several solutions are available to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is good enough to eliminate the trouble. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. You should examine the centering of the striker in connection with the trunk lock. If after looking at the trunk of your Bmw Serie 2 F22 closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk Bmw Serie 2 F22 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate replacement is done, to take out the old one the process used is to drill the existing rivets in order to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Bmw Serie 2 F22 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to discern the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take out the bumper to remove the bits of rivet that are running around.
