It is never pleasing to listen to a noise from your car you don’t know where from. Then what if you identify a serpentine belt noise that stays on your Mazda CX 30? It is very conceivable that this is a unimportant problem, but before being sure, it is better to carry out some inspections. If this belt noise comes from your serpentine or driving belt, our team has written an article to support you finding and correcting it. First, we will look at the serpentine belt noises on your Mazda CX 30 and then we will take a look at the sources of these noises.
I experience noises from serpentine belt Mazda CX 30
The best technique to check the condition of your belts is to listen to your vehicle. Immediately after you find noises such as squealing or bells, you should take a closer look to verify their source. The task of the serpentine belt or driving belt of your Mazda CX 30 is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore important in the normal functionality of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive different engine components at variable speeds.
I listen to squealing noises on my serpentine belt Mazda CX 30
This type of squealing belt noises on Mazda CX 30, which will often be acute, can commonly occur when the engine is cold, or when the acceleration increases in intensity. . This type of sound must be heavy and it is often quite simple to connect it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being visible, it should not be too difficult for you to point a belt noise on your Mazda CX 30. The reason of this problem can be in connection with the damper pulley, which operates as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the opportunity that this event is annodine. As the serpentine belt of your Mazda CX 30 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to verify the condition of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises Mazda CX 30
Just like squealing, a driving belt noise on your Mazda CX 30 that sounds like a loud grinding sound can say a lot about its condition. It is therefore imperative that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Don’t forget to verify first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to swap the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my Mazda CX 30
Finally, if in your case you discern a bearing belt noise on Mazda CX 30, it is conceivable that it is in connection with a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses possibilities, you still perceive a belt noises, read our article about timing belt noises on Mazda CX 30 which could maybe help you.