It is never enjoyable to listen to a noise from your car you don’t know where from. Thus what if you locate a serpentine belt noise that persists on your Kia Xceed? It is very conceivable that this is a minimal issue, but before being sure, it is better to carry out some checks. If this belt noise comes from your serpentine or driving belt, our team has written a page to support you finding and correcting it. First, we will look at the serpentine belt noises on your Kia Xceed and then we will take a look at the sources of these sounds.serpentine-belt-noise-kia-xceed

I experience noises from serpentine belt Kia Xceed

The best technique to check the state of your belts is to listen to your automobile. Immediately after you recognize sounds such as squealing or bells, you should take a closer look to check their source. The function of the serpentine belt or driving belt of your Kia Xceed is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal operation of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.

I listen to squealing noises on my serpentine belt Kia Xceed

This sort of squealing belt noises on Kia Xceed, which will often be acute, can generally arise when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be significant and it is obviously quite simple to associate it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being accessible, it should not be too complicated for you to point a belt noise on your Kia Xceed. The reason of this issue can be linked to the damper pulley, which works as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this event is annodine. As the serpentine belt of your Kia Xceed is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to check the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.

I listen to loud serpentine or driving belt noises Kia Xceed

Just like squealing, a driving belt noise on your Kia Xceed that sounds like a loud grinding sound can tell you a lot about its state. It is therefore imperative that you look further and locate the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this issue. Make sure to check first the serpentine/driving belt which in most cases is the reason of this issue, otherwise it will be necessary to swap the tensioner or pulley.

I listen to bearing noises on the serpentine belt of my Kia Xceed

Finally, if in your case you recognize a bearing belt noise on Kia Xceed, it is conceivable that it is linked to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than recommended and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses possibilities, you still identify a belt noises, read our article about timing belt noises on Kia Xceed which could maybe help you.