It is never pleasurable to listen to a noise from your car you don’t know where from. So what if you locate a serpentine belt noise that stays on your hyundai i20? It is very conceivable that this is a unimportant trouble, but before being sure, it is better to execute some investigations. If this belt noise comes from your serpentine or driving belt, our team has written a document to support you locating and repairing it. First, we will look at the serpentine belt noises on your hyundai i20 and then we will check out the sources of these sounds.
I encounter noises from serpentine belt hyundai i20
The best method to control the state of your belts is to listen to your automobile. Immediately after you find sounds such as squealing or bells, you should take a closer look to examine their source. The job of the serpentine belt or driving belt of your hyundai i20 is to transfer the movement of the engine to the secondary parts that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal general performance of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine parts at variable speeds.
I listen to squealing noises on my serpentine belt hyundai i20
This kind of squealing belt noises on hyundai i20, which will often be acute, can usually happen when the engine is cold, or when the acceleration increases in intensity. . This kind of noise must be heavy and it is normally quite simple to connect it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being accessible, it should not be too complicated for you to locate a belt noise on your hyundai i20. The reason of this trouble can be in connection with the damper pulley, which functions as a damper to get rid of irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this phenomenon is annodine. As the serpentine belt of your hyundai i20 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Keep in mind to examine the state of your belt (crack, crack), if this is the case swap it, otherwise simply tighten the belt.
I listen to loud serpentine or driving belt noises hyundai i20
Just like squealing, a driving belt noise on your hyundai i20 that sounds like a loud grinding sound can reveal a lot about its state. It is therefore necessary that you look further and find the cause for this sound that can signal the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this trouble. Make sure you examine first the serpentine/driving belt which in most cases is the reason of this trouble, otherwise it will be necessary to swap the tensioner or pulley.
I listen to bearing noises on the serpentine belt of my hyundai i20
Finally, if in your case you distinguish a bearing belt noise on hyundai i20, it is conceivable that it is in connection with a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to change it if it is too short. If after checking all thoses possibilities, you still identify a belt noises, read our article about timing belt noises on hyundai i20 which could maybe help you.
