It is never enjoyable to discover a noise from your car you don’t know where from. Thus what if you notice a serpentine belt noise that stays on your Fiat Panda 2? It is highly conceivable that this is a minimal issue, but before being sure, it is better to carry out some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a content to support you locating and fixing it. First, we will look at the serpentine belt noises on your Fiat Panda 2 and then we will check out the origins of these noises.
I feel noises from serpentine belt Fiat Panda 2
The best strategy to control the condition of your belts is to listen to your automobile. As soon as you notice noises such as squealing or bells, you should take a closer look to examine their origin. The role of the serpentine belt or driving belt of your Fiat Panda 2 is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore critical in the normal functionality of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine components at variable speeds.
I discover squealing noises on my serpentine belt Fiat Panda 2
This kind of squealing belt noises on Fiat Panda 2, which will often be acute, can in most cases occur when the engine is cold, or when the acceleration increases in intensity. . This kind of sound must be heavy and it is often quite simple to link it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being visible, it should not be too difficult for you to identify a belt noise on your Fiat Panda 2. The cause of this issue can be related to the damper pulley, which acts as a damper to eliminate irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this phenomenon is annodine. As the serpentine belt of your Fiat Panda 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to examine the condition of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I discover loud serpentine or driving belt noises Fiat Panda 2
Just like squealing, a driving belt noise on your Fiat Panda 2 that sounds like a loud grinding sound can reveal a lot about its condition. It is therefore essential that you look further and find the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this issue. Make sure you examine first the serpentine/driving belt which in most cases is the cause of this issue, otherwise it will be necessary to change the tensioner or pulley.
I discover bearing noises on the serpentine belt of my Fiat Panda 2
Finally, if in your case you discern a bearing belt noise on Fiat Panda 2, it is conceivable that it is related to a serpentine belt that is too tight . Indeed, it is conceivable that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still detect a belt noises, read our article about timing belt noises on Fiat Panda 2 which could maybe help you.
