It is never pleasant to notice a noise from your car you don’t know where from. Thus what if you locate a serpentine belt noise that stays on your Fiat Bravo 2? It is extremely plausible that this is a insignificant trouble, but before being sure, it is better to conduct some checks. If this belt noise comes from your serpentine or driving belt, our team has written a content to help you finding and fixing it. First, we will look at the serpentine belt noises on your Fiat Bravo 2 and then we will check out the sources of these sounds.
I encounter noises from serpentine belt Fiat Bravo 2
The best way to control the state of your belts is to listen to your car. As soon as you recognise sounds such as squealing or bells, you should take a closer look to examine their origin. The job of the serpentine belt or driving belt of your Fiat Bravo 2 is to transmit the movement of the engine to the secondary elements that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore fundamental in the normal operation of your car. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the capacity to drive distinctive engine elements at variable speeds.
I notice squealing noises on my serpentine belt Fiat Bravo 2
This sort of squealing belt noises on Fiat Bravo 2, which will often be acute, can usually arise when the engine is cold, or when the acceleration increases in intensity. . This sort of noise must be significant and it is normally quite simple to connect it with one of these belts. To examine, do not hesitate to open your bonnet, engine running cold and check the origin of this noise, the serpentine or driving belt being accessible, it should not be too difficult for you to point a belt noise on your Fiat Bravo 2. The reason of this trouble can be connected to the damper pulley, which operates as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have the possibility that this phenomenon is annodine. As the serpentine belt of your Fiat Bravo 2 is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Keep in mind to examine the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I notice loud serpentine or driving belt noises Fiat Bravo 2
Just like squealing, a driving belt noise on your Fiat Bravo 2 that sounds like a loud grinding sound can tell you a lot about its state. It is therefore important that you look further and find the reason for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the origin of this trouble. Don’t forget to examine first the serpentine/driving belt which in most cases is the reason of this trouble, otherwise it will be necessary to replace the tensioner or pulley.
I notice bearing noises on the serpentine belt of my Fiat Bravo 2
Finally, if in your case you distinguish a bearing belt noise on Fiat Bravo 2, it is plausible that it is connected to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses alternatives, you still notice a belt noises, read our article about timing belt noises on Fiat Bravo 2 which could maybe help you.
