It is never relaxing to find out a noise from your car you don’t know where from. So what if you notice a serpentine belt noise that persists on your Dodge Caliber? It is highly plausible that this is a unimportant problem, but before being sure, it is better to accomplish some verifications. If this belt noise comes from your serpentine or driving belt, our team has written a post to support you finding and fixing it. First, we will look at the serpentine belt noises on your Dodge Caliber and then we will take a look at the origins of these sounds.
I feel noises from serpentine belt Dodge Caliber
The best strategy to control the state of your belts is to listen to your automobile. As soon as you recognise sounds such as squealing or bells, you should take a closer look to check their source. The job of the serpentine belt or driving belt of your Dodge Caliber is to transmit the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore essential in the normal performance of your automobile. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive distinctive engine components at variable speeds.
I find out squealing noises on my serpentine belt Dodge Caliber
This kind of squealing belt noises on Dodge Caliber, which will often be acute, can mostly arise when the engine is cold, or when the acceleration increases in intensity. . This kind of sound must be heavy and it is normally quite simple to link it with one of these belts. To check, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being apparent, it should not be too difficult for you to identify a belt noise on your Dodge Caliber. The reason of this problem can be connected to the damper pulley, which functions as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have an opportunity that this phenomenon is annodine. As the serpentine belt of your Dodge Caliber is exposed, it may squeak due to excessive humidity due to weather conditions and it may stop with a change in conditions. Remember to check the state of your belt (crack, crack), if this is the case change it, otherwise simply tighten the belt.
I find out loud serpentine or driving belt noises Dodge Caliber
Just like squealing, a driving belt noise on your Dodge Caliber that sounds like a loud grinding sound can tell you a lot about its state. It is therefore essential that you look further and locate the reason for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven properly. Other alternatives, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Make sure to check first the serpentine/driving belt which in most cases is the reason of this problem, otherwise it will be necessary to change the tensioner or pulley.
I find out bearing noises on the serpentine belt of my Dodge Caliber
Finally, if in your case you distinguish a bearing belt noise on Dodge Caliber, it is plausible that it is connected to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than prescribed and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The problem in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to replace it if it is too short. If after checking all thoses alternatives, you still identify a belt noises, read our article about timing belt noises on Dodge Caliber which could maybe help you.
