It is never pleasant to hear a noise from your car you don’t know where from. Then what if you identify a serpentine belt noise that persists on your Chrysler 200? It is extremely plausible that this is a minimal problem, but before being sure, it is better to execute some inspections. If this belt noise comes from your serpentine or driving belt, our team has written a page to support you locating and fixing it. First, we will look at the serpentine belt noises on your Chrysler 200 and then we will look at the origins of these sounds.
I encounter noises from serpentine belt Chrysler 200
The best strategy to check the state of your belts is to listen to your vehicle. As soon as you detect sounds such as squealing or bells, you should take a closer look to verify their source. The function of the serpentine belt or driving belt of your Chrysler 200 is to transfer the movement of the engine to the secondary components that it will supply with energy. Like steering, air conditioning, water pump. Its role is therefore critical in the normal use of your vehicle. The serpentine belt is said to be asynchronous, i.e. unlike the timing belt, it has the ability to drive different engine components at variable speeds.
I hear squealing noises on my serpentine belt Chrysler 200
This kind of squealing belt noises on Chrysler 200, which will often be acute, can mostly arise when the engine is cold, or when the acceleration increases in intensity. . This kind of sound must be heavy and it is normally quite simple to connect it with one of these belts. To verify, do not hesitate to open your bonnet, engine running cold and check the source of this noise, the serpentine or driving belt being exposed, it should not be too difficult for you to point a belt noise on your Chrysler 200. The cause of this problem can be connected to the damper pulley, which works as a damper to reduce irregularities in the tension in the motor cycle and therefore in the energy transmission to the belt. This results in a loose belt that will jerk. However, you still have a chance that this phenomenon is annodine. As the serpentine belt of your Chrysler 200 is exposed, it may squeak due to excessive humidity due to weather conditions and it may end with a change in conditions. Remember to verify the state of your belt (crack, crack), if this is the case replace it, otherwise simply tighten the belt.
I hear loud serpentine or driving belt noises Chrysler 200
Just like squealing, a driving belt noise on your Chrysler 200 that sounds like a loud grinding sound can reveal a lot about its state. It is therefore necessary that you look further and find the cause for this sound that can indicate the end of your belt’s life. Like squealing noise, it can be identified in most cases when cold . It generally means a worn pulley whose streaks no longer allow it to be driven correctly. Other possibilities, the dynamic belt tensioner or the disengageable pulley of the alternator may be at the source of this problem. Don’t forget to verify first the serpentine/driving belt which in most cases is the cause of this problem, otherwise it will be necessary to replace the tensioner or pulley.
I hear bearing noises on the serpentine belt of my Chrysler 200
Finally, if in your case you recognize a bearing belt noise on Chrysler 200, it is plausible that it is connected to a serpentine belt that is too tight . Indeed, it is plausible that its size may be smaller than suggested and cause the entire system to overvoltage, resulting in this whistling noise or slight rolling noise. The risk in this case is that the bearing bearings or the Damper pulley may fail . Remember, therefore, to stretch the belt to limit the risks or to swap it if it is too short. If after checking all thoses possibilities, you still perceive a belt noises, read our article about timing belt noises on Chrysler 200 which could maybe help you.
