You acknowledge a starter motor noise on your Volkswagen Touran 2 once you start your vehicle. We can understand that this is not agreeable and that you have inquiries. Discovering such a noise is not always a good signal, but it may also be nothing significant. To support you remedy this problem, our team has chosen to produce this content page to help you in this research. First, we will detail how the starter motor functions on your Volkswagen Touran 2, and then what starter motor noises you can experience on your Volkswagen Touran 2.
Functioning and various information
Function of a starter motor on Volkswagen Touran 2
The starter motor is an electric motor whose only function is to start the engine motor of your vehicle. By a magnetic system and a “serial” technology, it will launch an enormous torque that will allow it to drive the pistons of the engine that are subjected to enormous compression and an oil that provides additional resistance being not very fluid when cold.
It is completed by the “solenoid”. It is an electromagnet that goes under a 12 volt electric impulse to push the fork (link element between the “solenoid” and the electric motor of the starter) and thus engage the starter drive pinion on the engine flywheel. Following this action, once in engagement, the starter motor of your Volkswagen Touran 2 is activated and turns the drive pinion on the flywheel to start the engine.
How to avoid starter motor noises on Volkswagen Touran 2
- Do not run your starter too long
- Do not use a starter motor on Volkswagen Touran 2 with a tired battery
Regardless if your engine does not start because of tired glow plugs, for example, or because the weather conditions is too cold. You should not turn your key for more than a few seconds or you will burn your starter motor.
Although when you have a battery that is exhausted, you always want to start your vehicle, the energy it is capable of holding may not be good enough to give the power expected by the starter motor to start your engine motor. Repeated attempts will pre-use your starter motor and if you do not resolve the cause of your failure to start repeatedly, your starter may be the future element you will have to swap.
I acknowledge noises from the starter motor of my Volkswagen Touran 2, what are the reasons?
I feel a loud noise from the starter of my Volkswagen Touran 2
If you notice a starter motor noise on Volkswagen Touran 2 and you have the feeling that it is close to a loud noise, it is conceivable that it is the starter motor gears that are at the source of it. In fact, often when the part has been dismantled for other fixes, its adjustment in relation to the engine flywheel may no longer be optimal, in which circumstance the gears will be worn down after some time and will not slip and will no longer properly activate the engine when starting. Verify the state of the drive pinion, if it is the component resposible of the starter motor noise on your Volkswagen Touran 2 change it.
If it is a noise in the front of your vehicle but it seems to you after reviewing not to come from your starter, consult this content page about front end noise on Volkswagen Touran 2 which may provide you other leads to eliminate your noise problem.
I acknowledge a clicking noise of the key running in my neiman but no noise at the starter motor of my Volkswagen Touran 2
If you acknowledge a clicking noise at the starter motor of your Volkswagen Touran 2, there are two possible failures relating to this symptom. If you have in addition to the noise the motor is not running, it may be the “solenoid” is not supplied with energy. One of the most traditional ways to relaunch it is to hit it with a metal bar to remove the dust that blocks it. If that is not enough, it may be the neiman who is involved. You could have a problem with unplugged cable examine your electrical installation. If after looking at this clicking noise on Volkswagen Touran 2 doesn’t come from your starter motor, check this article for more informations.
