If you identify a noise on your automobile, you are right to be attentive of it and take it seriously, although it is plausible that nothing significant will results, it is also plausible that it is the symptom of a more critical fix. A noise that shows up in the trunk of your seat altea is fortunately more a signal of a small manipulation or fix, rather than a complex one. To help you in your research, we have decided to generate this article to present you with the most likely solutions to your problem. First we will see that this trunk noise on your seat altea can come from built up dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk seat altea : Accumulated dirt that causes poor closing
>
We will therefore start with a trunk noise on your seat altea created by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this situation, open the trunk of your seat altea, examine the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your seat altea that is relating to other origins such as shock absorbers, do not hesitate to read this article on the noises at the back of a seat altea.
Noise in the trunk of my seat altea : Loose lock, clicking noise
Second probability, you may also, over time, be the victim of a locking system that has taken up some play. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your seat altea is very frequently relating to this problem. Some solutions are existing to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is appropriate to fix the issue. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that will allow access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Don’t forget to verify the centering of the striker in connection with the trunk lock. If after verifying the trunk of your seat altea closes badly, it means that you have moved it too far, replicate the procedure by pushing the striker less.
Noise in my trunk seat altea : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate change is done, to remove the old one the strategy used is to drill the existing rivets to be able to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your seat altea linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to specify the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant case, you will have to remove the bumper to remove the bits of rivet that are running around.
