If you find a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will results, it is also conceivable that it is the symptom of a more significant repair. A noise that happens in the trunk of your Toyota C HR is thankfully more a signal of a small manipulation or repair, rather than a difficult one. To support you in your research, we have decided to generate this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Toyota C HR can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota C HR : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Toyota C HR generated by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Toyota C HR, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota C HR that is linked to other sources such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Toyota C HR.
Noise in the trunk of my Toyota C HR : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that became loose. And this is one of the most probably possibilities. In fact, knowing a trunk noise on your Toyota C HR is very often linked to this issue. Different solutions are available to you depending on the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the mechanism with thick grease is appropriate to fix the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take out the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Remember to verify the centering of the striker in relation to the trunk lock. If after verifying the trunk of your Toyota C HR closes badly, it means that you have moved it too far, repeat the procedure by pushing the striker less.
Noise in my trunk Toyota C HR : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate replacement is done, to take out the old one the strategy used is to drill the existing rivets in order to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can trigger an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota C HR linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to define the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to take out the bumper to remove the bits of rivet that are running around.
