If you find out a noise on your automobile, you are right to be aware of it and take it seriously, although it is possible that nothing significant will occur, it is also possible that it is the indication of a more critical fix. A noise that occurs in the trunk of your Ford Taurus is fortunately more a indication of a small correction or repair, rather than a complex one. To help you in your research, we have decided to produce this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Ford Taurus can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Ford Taurus : Built up dirt that triggers poor closing
>
We will therefore start with a trunk noise on your Ford Taurus triggered by dirt accumulated on your joints, lock for example. In fact, it is possible that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Ford Taurus, verify the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Ford Taurus that is linked to other sources such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Ford Taurus.
Noise in the trunk of my Ford Taurus : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that has taken up some play. And this is one of the most likely possibilities. In fact, knowing a trunk noise on your Ford Taurus is very frequently linked to this issue. Some solutions are existing to you subject to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to solve the trouble. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to remove the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Don’t forget to examine the centering of the striker in relation to the trunk lock. If after examining the trunk of your Ford Taurus closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Ford Taurus : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell behind your plate. In fact, when a plate replacement is made, to take off the old one the procedure used is to drill the existing rivets to be able to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Ford Taurus linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to define the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to take off the bumper to remove the bits of rivet that are running around.
