If you find out a noise on your car, you are right to be careful of it and take it seriously, although it is conceivable that nothing critical will happen, it is also conceivable that it is the signal of a more important restoration. A noise that comes out in the trunk of your Volkswagen Transporter is thankfully more a indicator of a small adjustment or repair, rather than a complicated one. To help you in your research, we have decided to compose this article to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Volkswagen Transporter can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Volkswagen Transporter : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Volkswagen Transporter created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt collects at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Volkswagen Transporter, examine the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Volkswagen Transporter that is connected to other sources such as shock absorbers, do not hesitate to consult this article on the noises at the back of a Volkswagen Transporter.
Noise in the trunk of my Volkswagen Transporter : Loose lock, clicking noise
Second probability, you may also, over time, be the victim of a locking system that has taken up some play. And this is one of the most probably alternatives. In fact, knowing a trunk noise on your Volkswagen Transporter is very frequently connected to this issue. Different solutions are existing to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to resolve the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that will allow access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in connection with the trunk lock. If after checking the trunk of your Volkswagen Transporter closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Volkswagen Transporter : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is done, to remove the old one the strategy used is to drill the existing rivets in order to released the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Volkswagen Transporter linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to identify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
