If you find a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing critical will occur, it is also conceivable that it is the indication of a more critical restoration. A noise that appears in the trunk of your Toyota Land Cruiser Serie 70 is thankfully more a indication of a small correction or service, rather than a difficult one. To help you in your research, we have decided to generate this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Toyota Land Cruiser Serie 70 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota Land Cruiser Serie 70 : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Toyota Land Cruiser Serie 70 created by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a car that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this scenario, open the trunk of your Toyota Land Cruiser Serie 70, examine the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota Land Cruiser Serie 70 that is relating to other sources such as shock absorbers, do not hesitate to consult this content on the noises at the back of a Toyota Land Cruiser Serie 70.
Noise in the trunk of my Toyota Land Cruiser Serie 70 : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most potential possibilities. Indeed, knowing a trunk noise on your Toyota Land Cruiser Serie 70 is very often relating to this issue. Some solutions are existing to you according to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is more than enough to solve the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should check the centering of the striker in regards to the trunk lock. If after checking the trunk of your Toyota Land Cruiser Serie 70 closes badly, it means that you have moved it too far, repeat the process by pushing the striker less.
Noise in my trunk Toyota Land Cruiser Serie 70 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell behind your plate. Indeed, when a plate change is done, to take off the old one the process used is to drill the existing rivets in order to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota Land Cruiser Serie 70 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to identify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to take off the bumper to remove the bits of rivet that are running around.
