If you identify a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing serious will happen, it is also conceivable that it is the signal of a more significant restoration. A noise that comes out in the trunk of your Toyota Land Cruiser Serie 120 is thankfully more a indicator of a small adjustment or repair, rather than a difficult one. To support you in your research, we have chosen to write this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Toyota Land Cruiser Serie 120 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Toyota Land Cruiser Serie 120 : Accumulated dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Toyota Land Cruiser Serie 120 induced by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a car that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt collects at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this circumstance, open the trunk of your Toyota Land Cruiser Serie 120, check the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Toyota Land Cruiser Serie 120 that is linked to other sources such as shock absorbers, do not hesitate to have a look to this content page on the noises at the back of a Toyota Land Cruiser Serie 120.
Noise in the trunk of my Toyota Land Cruiser Serie 120 : Loose lock, clicking noise
Second probability, you may also, over time, knowledge a locking system that became loose. And this is one of the most probably alternatives. Indeed, knowing a trunk noise on your Toyota Land Cruiser Serie 120 is very frequently linked to this issue. Several solutions are available to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the system with thick grease is sufficient to resolve the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should check the centering of the striker in relation to the trunk lock. If after examining the trunk of your Toyota Land Cruiser Serie 120 closes badly, it means that you have moved it too far, duplicate the operation by pushing the striker less.
Noise in my trunk Toyota Land Cruiser Serie 120 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell behind your plate. Indeed, when a plate swap is done, to take out the old one the process used is to drill the existing rivets to be able to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Toyota Land Cruiser Serie 120 linked to a rivet, you will need to check that it is in the tailgate open it and stir it to define the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant situation, you will have to take out the bumper to remove the bits of rivet that are running around.
