If you detect a noise on your car, you are right to be attentive of it and take it seriously, although it is conceivable that nothing major will result, it is also conceivable that it is the indication of a more critical fix. A noise that comes out in the trunk of your Subaru Legacy is fortunately more a indication of a small correction or restoration, rather than a complicated one. To help you in your research, we have chosen to generate this article to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Subaru Legacy can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Subaru Legacy : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Subaru Legacy generated by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your Subaru Legacy, examine the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Subaru Legacy that is related to other origins such as shock absorbers, do not hesitate to read this article on the noises at the back of a Subaru Legacy.
Noise in the trunk of my Subaru Legacy : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Subaru Legacy is very often related to this issue. Some solutions are existing to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the mechanism with thick grease is more than enough to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that will allow access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in regards to the trunk lock. If after examining the trunk of your Subaru Legacy closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk Subaru Legacy : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate replacement is made, to take out the old one the process used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Subaru Legacy linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic case, you will have to take out the bumper to remove the bits of rivet that are running around.
