If you acknowledge a noise on your vehicle, you are right to be aware of it and take it seriously, although it is conceivable that nothing serious will happen, it is also conceivable that it is the indication of a more important fix. A noise that shows up in the trunk of your seat cordoba is fortunately more a indication of a small correction or fix, rather than a complex one. To support you in your research, we have chosen to write this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your seat cordoba can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk seat cordoba : Accumulated dirt that causes poor closing
>
We will therefore start with a trunk noise on your seat cordoba triggered by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this situation, open the trunk of your seat cordoba, verify the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your seat cordoba that is relating to other sources such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a seat cordoba.
Noise in the trunk of my seat cordoba : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that has taken up some play. And this is one of the most probably alternatives. Indeed, knowing a trunk noise on your seat cordoba is very frequently relating to this issue. Different solutions are existing to you subject to the level of play you have with your lock. The first is that sometimes the offset is minimal and a simple greasing of the system with thick grease is good enough to solve the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. You should examine the centering of the striker in relation to the trunk lock. If after checking out the trunk of your seat cordoba closes badly, it means that you have moved it too far, replicate the operation by pushing the striker less.
Noise in my trunk seat cordoba : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell behind your plate. Indeed, when a plate swap is made, to remove the old one the strategy used is to drill the existing rivets in order to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your seat cordoba linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing case, you will have to remove the bumper to remove the bits of rivet that are running around.
