If you detect a noise on your vehicle, you are right to be concerned of it and take it seriously, although it is conceivable that nothing significant will results, it is also conceivable that it is the sign of a more important restoration. A noise that occurs in the trunk of your Ram ProMaster City is luckily more a indication of a small manipulation or service, rather than a complex one. To help you in your research, we have decided to compose this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Ram ProMaster City can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-ram-promaster-city

Noise in the trunk Ram ProMaster City : Accumulated dirt that triggers poor closing

>
We will therefore begin with a trunk noise on your Ram ProMaster City generated by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Ram ProMaster City, verify the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Ram ProMaster City that is connected to other sources such as shock absorbers, do not hesitate to have a look to this content on the noises at the back of a Ram ProMaster City.

Noise in the trunk of my Ram ProMaster City : Loose lock, clicking noise

Second probability, you may also, over time, knowledge a locking system that became loose. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Ram ProMaster City is very frequently connected to this issue. Several solutions are available to you depending on the level of play you have with your lock. The first is that sometimes the offset is minimal and a simple greasing of the system with thick grease is enough to solve the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Remember to examine the centering of the striker in connection with the trunk lock. If after verifying the trunk of your Ram ProMaster City closes badly, it means that you have moved it too far, replicate the procedure by pushing the striker less.

Noise in my trunk Ram ProMaster City : Rivet following plate change in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is done, to remove the old one the procedure used is to drill the existing rivets in order to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Ram ProMaster City linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant case, you will have to remove the bumper to remove the bits of rivet that are running around.