If you find out a noise on your automobile, you are right to be attentive of it and take it seriously, although it is plausible that nothing significant will occur, it is also plausible that it is the signal of a more critical restoration. A noise that shows up in the trunk of your Peugeot Rifter is thankfully more a signal of a small adjustment or service, rather than a complex one. To help you in your research, we have chosen to write this content to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Peugeot Rifter can come from built up dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Peugeot Rifter : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Peugeot Rifter generated by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a automobile that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this situation, open the trunk of your Peugeot Rifter, examine the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Peugeot Rifter that is relating to other sources such as shock absorbers, do not hesitate to consult this content on the noises at the back of a Peugeot Rifter.
Noise in the trunk of my Peugeot Rifter : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that became loose. And this is one of the most probably alternatives. In fact, knowing a trunk noise on your Peugeot Rifter is very frequently relating to this trouble. Several solutions are existing to you according to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the mechanism with thick grease is enough to fix the issue. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that will allow access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to examine the centering of the striker in connection with the trunk lock. If after checking out the trunk of your Peugeot Rifter closes badly, it means that you have moved it too far, replicate the process by pushing the striker less.
Noise in my trunk Peugeot Rifter : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell behind your plate. In fact, when a plate replacement is done, to take off the old one the technique used is to drill the existing rivets to be able to released the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Peugeot Rifter linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to take off the bumper to remove the bits of rivet that are running around.
