If you notice a noise on your automobile, you are right to be attentive of it and take it seriously, although it is possible that nothing major will happen, it is also possible that it is the signal of a more significant repair. A noise that occurs in the trunk of your Peugeot Expert is thankfully more a signal of a small correction or restoration, rather than a complex one. To support you in your research, we have chosen to produce this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Peugeot Expert can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Peugeot Expert : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Peugeot Expert caused by dirt accumulated on your joints, lock for example. Indeed, it is possible that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt collects at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your Peugeot Expert, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Peugeot Expert that is relating to other origins such as shock absorbers, do not hesitate to read this content page on the noises at the back of a Peugeot Expert.
Noise in the trunk of my Peugeot Expert : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that became loose. And this is one of the most potential alternatives. Indeed, knowing a trunk noise on your Peugeot Expert is very frequently relating to this issue. Some solutions are existing to you according to the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to solve the issue. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to strip off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Don’t forget to examine the centering of the striker in connection with the trunk lock. If after verifying the trunk of your Peugeot Expert closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Peugeot Expert : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell behind your plate. Indeed, when a plate change is made, to remove the old one the process used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Peugeot Expert linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant case, you will have to remove the bumper to remove the bits of rivet that are running around.
