If you notice a noise on your car, you are right to be attentive of it and take it seriously, although it is conceivable that nothing significant will occur, it is also conceivable that it is the indication of a more important restoration. A noise that shows up in the trunk of your Mercedes Benz Sprinter is luckily more a indication of a small adjustment or restoration, rather than a complicated one. To help you in your research, we have decided to write this article to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Mercedes Benz Sprinter can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-mercedes-benz-sprinter

Noise in the trunk Mercedes Benz Sprinter : Accumulated dirt that causes poor closing

>
We will therefore begin with a trunk noise on your Mercedes Benz Sprinter created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a car that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt collects at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this condition, open the trunk of your Mercedes Benz Sprinter, examine the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Mercedes Benz Sprinter that is linked to other origins such as shock absorbers, do not hesitate to consult this article on the noises at the back of a Mercedes Benz Sprinter.

Noise in the trunk of my Mercedes Benz Sprinter : Loose lock, clicking noise

Second probability, you may also, over time, knowledge a locking system that became loose. And this is one of the most probably alternatives. In fact, knowing a trunk noise on your Mercedes Benz Sprinter is very frequently linked to this issue. Different solutions are existing to you subject to the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the mechanism with thick grease is sufficient to fix the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Be sure you examine the centering of the striker in regards to the trunk lock. If after verifying the trunk of your Mercedes Benz Sprinter closes badly, it means that you have moved it too far, repeat the procedure by pushing the striker less.

Noise in my trunk Mercedes Benz Sprinter : Rivet following plate swap in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. In fact, when a plate change is made, to take out the old one the process used is to drill the existing rivets to be able to put out the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Mercedes Benz Sprinter linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to take out the bumper to remove the bits of rivet that are running around.