If you notice a noise on your car, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will result, it is also conceivable that it is the indication of a more critical restoration. A noise that occurs in the trunk of your Mercedes Benz GL Class is thankfully more a indication of a small manipulation or repair, rather than a complex one. To support you in your research, we have chosen to write this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Mercedes Benz GL Class can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Mercedes Benz GL Class : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Mercedes Benz GL Class caused by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a car that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this condition, open the trunk of your Mercedes Benz GL Class, verify the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Mercedes Benz GL Class that is connected to other origins such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a Mercedes Benz GL Class.
Noise in the trunk of my Mercedes Benz GL Class : Loose lock, clicking noise
Second probability, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most probably alternatives. Indeed, knowing a trunk noise on your Mercedes Benz GL Class is very often connected to this issue. Several solutions are existing to you according to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the system with thick grease is sufficient to resolve the problem. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Don’t forget to examine the centering of the striker in regards to the trunk lock. If after verifying the trunk of your Mercedes Benz GL Class closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk Mercedes Benz GL Class : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell at the rear of your plate. Indeed, when a plate replacement is done, to remove the old one the process used is to drill the existing rivets in order to release the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can cause an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Mercedes Benz GL Class linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant situation, you will have to remove the bumper to remove the bits of rivet that are running around.
