If you acknowledge a noise on your vehicle, you are right to be careful of it and take it seriously, although it is plausible that nothing major will happen, it is also plausible that it is the indication of a more critical fix. A noise that happens in the trunk of your Infiniti QX60 is thankfully more a indicator of a small manipulation or repair, rather than a difficult one. To help you in your research, we have decided to compose this content to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Infiniti QX60 can come from built up dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Infiniti QX60 : Accumulated dirt that causes poor closing
>
We will therefore start with a trunk noise on your Infiniti QX60 generated by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt collects at the trunk gasket. This problem causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this condition, open the trunk of your Infiniti QX60, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Infiniti QX60 that is relating to other sources such as shock absorbers, do not hesitate to read this content on the noises at the back of a Infiniti QX60.
Noise in the trunk of my Infiniti QX60 : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Infiniti QX60 is very often relating to this problem. Different solutions are available to you according to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the mechanism with thick grease is enough to fix the issue. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Don’t forget to examine the centering of the striker in relation to the trunk lock. If after looking at the trunk of your Infiniti QX60 closes badly, it means that you have moved it too far, duplicate the operation by pushing the striker less.
Noise in my trunk Infiniti QX60 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is made, to remove the old one the technique used is to drill the existing rivets in order to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Infiniti QX60 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing situation, you will have to remove the bumper to remove the bits of rivet that are running around.
