If you find a noise on your vehicle, you are right to be careful of it and take it seriously, although it is possible that nothing serious will happen, it is also possible that it is the symptom of a more important repair. A noise that comes out in the trunk of your Hyundai Bayon is fortunately more a sign of a small adjustment or fix, rather than a complicated one. To support you in your research, we have chosen to compose this article to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Hyundai Bayon can come from built up dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Hyundai Bayon : Accumulated dirt that triggers poor closing
>
We will therefore begin with a trunk noise on your Hyundai Bayon created by dirt accumulated on your joints, lock for example. Indeed, it is possible that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble triggers a poor closure of the trunk and a noise that can sound like a crack. To check if you are in this scenario, open the trunk of your Hyundai Bayon, verify the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Hyundai Bayon that is related to other sources such as shock absorbers, do not hesitate to consult this article on the noises at the back of a Hyundai Bayon.
Noise in the trunk of my Hyundai Bayon : Loose lock, clicking noise
Second possibility, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most likely possibilities. Indeed, knowing a trunk noise on your Hyundai Bayon is very frequently related to this trouble. Different solutions are available to you subject to the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the system with thick grease is appropriate to resolve the problem. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Be sure you check the centering of the striker in relation to the trunk lock. If after looking at the trunk of your Hyundai Bayon closes badly, it means that you have moved it too far, duplicate the operation by pushing the striker less.
Noise in my trunk Hyundai Bayon : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell backside your plate. Indeed, when a plate change is done, to take off the old one the process used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can generate an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Hyundai Bayon linked to a rivet, you will need to check that it is in the tailgate open it and stir it to specify the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more unpleasant situation, you will have to take off the bumper to remove the bits of rivet that are running around.
