If you identify a noise on your automobile, you are right to be aware of it and take it seriously, although it is possible that nothing major will result, it is also possible that it is the sign of a more critical repair. A noise that appears in the trunk of your Honda Accord is thankfully more a indicator of a small adjustment or service, rather than a complicated one. To help you in your research, we have decided to produce this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Honda Accord can come from built up dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-honda-accord

Noise in the trunk Honda Accord : Accumulated dirt that causes poor closing

We will therefore begin with a trunk noise on your Honda Accord generated by dirt accumulated on your joints, lock for example. In fact, it is possible that on a automobile that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this situation, open the trunk of your Honda Accord, examine the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Honda Accord that is connected to other sources such as shock absorbers, do not hesitate to consult this content page on the noises at the back of a Honda Accord.

Noise in the trunk of my Honda Accord : Loose lock, clicking noise

Second probability, you may also, over time, knowledge a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Honda Accord is very frequently connected to this issue. Some solutions are available to you subject to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the system with thick grease is appropriate to eliminate the trouble. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in relation to the trunk lock. If after checking the trunk of your Honda Accord closes badly, it means that you have moved it too far, replicate the process by pushing the striker less.

Noise in my trunk Honda Accord : Rivet following plate swap in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell behind your plate. In fact, when a plate replacement is made, to take out the old one the procedure used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can induce an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Honda Accord linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to define the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more problematic case, you will have to take out the bumper to remove the bits of rivet that are running around.