If you detect a noise on your automobile, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will result, it is also conceivable that it is the sign of a more significant restoration. A noise that occurs in the trunk of your Ford Fusion is fortunately more a indicator of a small manipulation or service, rather than a complicated one. To support you in your research, we have chosen to generate this article to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Ford Fusion can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk Ford Fusion : Accumulated dirt that causes poor closing
>
We will therefore begin with a trunk noise on your Ford Fusion created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a automobile that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this situation, open the trunk of your Ford Fusion, check the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the impact. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Ford Fusion that is related to other origins such as shock absorbers, do not hesitate to read this article on the noises at the back of a Ford Fusion.
Noise in the trunk of my Ford Fusion : Loose lock, clicking noise
Second possibility, you may also, over time, experience a locking system that has taken up some play. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your Ford Fusion is very often related to this trouble. Some solutions are available to you subject to the level of play you have with your lock. The first is that occasionally the offset is minimal and a simple greasing of the mechanism with thick grease is more than enough to resolve the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Remember to verify the centering of the striker in relation to the trunk lock. If after verifying the trunk of your Ford Fusion closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.
Noise in my trunk Ford Fusion : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell backside your plate. In fact, when a plate change is done, to take off the old one the technique used is to drill the existing rivets in order to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Ford Fusion linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to specify the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take off the bumper to remove the bits of rivet that are running around.
