If you find a noise on your automobile, you are right to be aware of it and take it seriously, although it is possible that nothing significant will result, it is also possible that it is the signal of a more significant fix. A noise that occurs in the trunk of your Citroen C3 Pluriel is thankfully more a sign of a small adjustment or restoration, rather than a difficult one. To help you in your research, we have decided to generate this content to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Citroen C3 Pluriel can come from accumulated dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-citroen-c3-pluriel

Noise in the trunk Citroen C3 Pluriel : Accumulated dirt that triggers poor closing

>
We will therefore begin with a trunk noise on your Citroen C3 Pluriel generated by dirt accumulated on your joints, lock for example. In fact, it is possible that on a automobile that is already a few years old and whose cleaning is not always a top priority or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this circumstance, open the trunk of your Citroen C3 Pluriel, verify the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is possible however that you have a trunk noise on your Citroen C3 Pluriel that is relating to other origins such as shock absorbers, do not hesitate to read this content on the noises at the back of a Citroen C3 Pluriel.

Noise in the trunk of my Citroen C3 Pluriel : Loose lock, clicking noise

Second probability, you may also, over time, be the victim of a locking system that became loose. And this is one of the most probably possibilities. In fact, knowing a trunk noise on your Citroen C3 Pluriel is very frequently relating to this trouble. Several solutions are existing to you depending on the level of play you have with your lock. The first is that oftentimes the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to resolve the issue. Secondly, it is also possible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Make sure to examine the centering of the striker in connection with the trunk lock. If after verifying the trunk of your Citroen C3 Pluriel closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.

Noise in my trunk Citroen C3 Pluriel : Rivet following plate change in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate replacement is made, to remove the old one the strategy used is to drill the existing rivets in order to released the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Citroen C3 Pluriel linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to distinguish the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to remove the bumper to remove the bits of rivet that are running around.