If you detect a noise on your vehicle, you are right to be careful of it and take it seriously, although it is conceivable that nothing serious will results, it is also conceivable that it is the sign of a more critical fix. A noise that shows up in the trunk of your Chrysler 200 is fortunately more a sign of a small manipulation or restoration, rather than a complex one. To support you in your research, we have decided to generate this content to present you with the most likely solutions to your issue. First we will see that this trunk noise on your Chrysler 200 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-chrysler-200

Noise in the trunk Chrysler 200 : Accumulated dirt that triggers poor closing

>
We will therefore start with a trunk noise on your Chrysler 200 created by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This issue triggers a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this circumstance, open the trunk of your Chrysler 200, check the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the improvement. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Chrysler 200 that is linked to other sources such as shock absorbers, do not hesitate to have a look to this content on the noises at the back of a Chrysler 200.

Noise in the trunk of my Chrysler 200 : Loose lock, clicking noise

Second probability, you may also, over time, experience a locking system that has taken up some play. And this is one of the most potential alternatives. In fact, knowing a trunk noise on your Chrysler 200 is very frequently linked to this issue. Some solutions are existing to you subject to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the mechanism with thick grease is appropriate to eliminate the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to take out the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Be sure you examine the centering of the striker in connection with the trunk lock. If after looking at the trunk of your Chrysler 200 closes badly, it means that you have moved it too far, repeat the procedure by pushing the striker less.

Noise in my trunk Chrysler 200 : Rivet following plate change in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate change you were unlucky and that a piece of rivet fell behind your plate. In fact, when a plate change is done, to remove the old one the procedure used is to drill the existing rivets in order to put out the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Chrysler 200 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to define the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing case, you will have to remove the bumper to remove the bits of rivet that are running around.