If you acknowledge a noise on your vehicle, you are right to be careful of it and take it seriously, although it is plausible that nothing major will happen, it is also plausible that it is the indication of a more significant restoration. A noise that comes out in the trunk of your Chevrolet Corvette is luckily more a indication of a small manipulation or fix, rather than a complex one. To help you in your research, we have chosen to produce this content page to present you with the most likely solutions to your trouble. First we will see that this trunk noise on your Chevrolet Corvette can come from built up dirt, the trouble can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-chevrolet-corvette

Noise in the trunk Chevrolet Corvette : Built up dirt that triggers poor closing

>
We will therefore begin with a trunk noise on your Chevrolet Corvette triggered by dirt accumulated on your joints, lock for example. In fact, it is plausible that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt accumulates at the trunk gasket. This trouble triggers a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Chevrolet Corvette, examine the condition of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is plausible however that you have a trunk noise on your Chevrolet Corvette that is related to other sources such as shock absorbers, do not hesitate to have a look to this content page on the noises at the back of a Chevrolet Corvette.

Noise in the trunk of my Chevrolet Corvette : Loose lock, clicking noise

Second probability, you may also, over time, knowledge a locking system that became loose. And this is one of the most potential possibilities. In fact, knowing a trunk noise on your Chevrolet Corvette is very frequently related to this trouble. Different solutions are existing to you according to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the system with thick grease is sufficient to solve the trouble. Secondly, it is also plausible that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that allows access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to verify the centering of the striker in connection with the trunk lock. If after looking at the trunk of your Chevrolet Corvette closes badly, it means that you have moved it too far, repeat the procedure by pushing the striker less.

Noise in my trunk Chevrolet Corvette : Rivet following plate swap in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate swap you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is made, to take out the old one the technique used is to drill the existing rivets to be able to release the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Chevrolet Corvette linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to distinguish the noise. If this is your case, you will have to take out the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take out the bumper to remove the bits of rivet that are running around.