If you pay attention to a noise on your vehicle, you are right to be aware of it and take it seriously, although it is conceivable that nothing significant will results, it is also conceivable that it is the indication of a more critical restoration. A noise that appears in the trunk of your Chevrolet Captiva is fortunately more a sign of a small correction or service, rather than a complicated one. To support you in your research, we have decided to generate this content page to present you with the most likely solutions to your problem. First we will see that this trunk noise on your Chevrolet Captiva can come from built up dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.trunk-noise-chevrolet-captiva

Noise in the trunk Chevrolet Captiva : Accumulated dirt that causes poor closing

>
We will therefore begin with a trunk noise on your Chevrolet Captiva triggered by dirt accumulated on your joints, lock for example. Indeed, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this condition, open the trunk of your Chevrolet Captiva, verify the state of the gasket that runs around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your Chevrolet Captiva that is relating to other sources such as shock absorbers, do not hesitate to have a look to this content page on the noises at the back of a Chevrolet Captiva.

Noise in the trunk of my Chevrolet Captiva : Loose lock, clicking noise

Second probability, you may also, over time, encounter a locking system that became loose. And this is one of the most probably possibilities. Indeed, knowing a trunk noise on your Chevrolet Captiva is very often relating to this problem. Different solutions are available to you according to the level of play you have with your lock. The first is that quite often the offset is minimal and a simple greasing of the system with thick grease is more than enough to fix the trouble. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to remove the cover that enables access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. You should verify the centering of the striker in regards to the trunk lock. If after checking out the trunk of your Chevrolet Captiva closes badly, it means that you have moved it too far, repeat the operation by pushing the striker less.

Noise in my trunk Chevrolet Captiva : Rivet following plate swap in the trunk/ bumper

Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. Indeed, when a plate replacement is done, to take off the old one the procedure used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your Chevrolet Captiva linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to distinguish the noise. If this is your situation, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing situation, you will have to take off the bumper to remove the bits of rivet that are running around.