If you acknowledge a noise on your vehicle, you are right to be concerned of it and take it seriously, although it is conceivable that nothing serious will results, it is also conceivable that it is the signal of a more important fix. A noise that happens in the trunk of your BMW X6 is thankfully more a sign of a small manipulation or repair, rather than a complex one. To help you in your research, we have chosen to compose this content to present you with the most likely solutions to your problem. First we will see that this trunk noise on your BMW X6 can come from accumulated dirt, the problem can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk BMW X6 : Built up dirt that causes poor closing
>
We will therefore start with a trunk noise on your BMW X6 generated by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a priority or that the roads used are not very clean that dirt builds up at the trunk gasket. This problem causes a poor closure of the trunk and a noise that can sound like a crack. To examine if you are in this scenario, open the trunk of your BMW X6, check the state of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your BMW X6 that is connected to other sources such as shock absorbers, do not hesitate to consult this content on the noises at the back of a BMW X6.
Noise in the trunk of my BMW X6 : Loose lock, clicking noise
Second probability, you may also, over time, experience a locking system that became loose. And this is one of the most likely alternatives. In fact, knowing a trunk noise on your BMW X6 is very often connected to this problem. Different solutions are existing to you subject to the level of play you have with your lock. The first is that sometimes the offset is minimal and a simple greasing of the mechanism with thick grease is good enough to fix the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which case you would have to take out the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, just push it back a little towards the inside of the trunk and tighten it again. Make sure to examine the centering of the striker in regards to the trunk lock. If after checking out the trunk of your BMW X6 closes badly, it means that you have moved it too far, replicate the process by pushing the striker less.
Noise in my trunk BMW X6 : Rivet following plate swap in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate swap you were unlucky and that a piece of rivet fell backside your plate. In fact, when a plate change is made, to remove the old one the technique used is to drill the existing rivets to be able to released the license plate. Sadly, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can provoke an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your BMW X6 linked to a rivet, you will need to examine that it is in the tailgate open it and stir it to specify the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more disturbing case, you will have to remove the bumper to remove the bits of rivet that are running around.
