If you find out a noise on your vehicle, you are right to be concerned of it and take it seriously, although it is conceivable that nothing serious will occur, it is also conceivable that it is the signal of a more important restoration. A noise that appears in the trunk of your BMW i3 is thankfully more a sign of a small manipulation or restoration, rather than a complex one. To support you in your research, we have chosen to produce this content page to present you with the most likely solutions to your issue. First we will see that this trunk noise on your BMW i3 can come from accumulated dirt, the issue can also come from a loose lock and finally, it can even come from a simple rivet that sits inside your bumper.
Noise in the trunk BMW i3 : Built up dirt that causes poor closing
>
We will therefore begin with a trunk noise on your BMW i3 caused by dirt accumulated on your joints, lock for example. In fact, it is conceivable that on a vehicle that is already a few years old and whose cleaning is not always a main concern or that the roads used are not very clean that dirt collects at the trunk gasket. This issue causes a poor closure of the trunk and a noise that can sound like a crack. To verify if you are in this circumstance, open the trunk of your BMW i3, verify the condition of the gasket that goes around the entire tailgate and clean it with a wet/soap cloth, dry the whole thing and try to close the trunk and take a dentred road to see the difference. If this is not the case, continue to the other hypotheses that will probably give a solution. It is conceivable however that you have a trunk noise on your BMW i3 that is related to other origins such as shock absorbers, do not hesitate to read this content page on the noises at the back of a BMW i3.
Noise in the trunk of my BMW i3 : Loose lock, clicking noise
Second possibility, you may also, over time, be the victim of a locking system that has taken up some play. And this is one of the most likely possibilities. In fact, knowing a trunk noise on your BMW i3 is very frequently related to this issue. Several solutions are existing to you subject to the level of play you have with your lock. The first is that in some cases the offset is minimal and a simple greasing of the system with thick grease is more than enough to fix the issue. Secondly, it is also conceivable that you really have a lot of play on your lock and that each time the trunk “jumps”, in which circumstance you would have to strip off the cover that permits access to the lock (inside the trunk). Then, using torx screws, you unscrew the striker attached to the threshold, simply push it back a little towards the inside of the trunk and tighten it again. Make sure to verify the centering of the striker in regards to the trunk lock. If after checking out the trunk of your BMW i3 closes badly, it means that you have moved it too far, duplicate the procedure by pushing the striker less.
Noise in my trunk BMW i3 : Rivet following plate change in the trunk/ bumper
Finally, one of the last possibilities. It is that following a license plate change you were unfortunate and that a piece of rivet fell at the rear of your plate. In fact, when a plate swap is done, to take off the old one the strategy used is to drill the existing rivets to be able to release the license plate. Unfortunately, it can happen that part of the rivet falls into the hole of the bumper and it will therefore wander inside the bumper and can create an annoying noise. To check that it is this problem you are experiencing, and that you have a trunk noise on your BMW i3 linked to a rivet, you will need to verify that it is in the tailgate open it and stir it to discern the noise. If this is your case, you will have to remove the linings from the trunk to remove it. Finally, if it is your bumper, it is in this rarer and more embarrassing case, you will have to take off the bumper to remove the bits of rivet that are running around.
