You acknowledge a starter motor noise on your Subaru Crosstrek once you start your vehicle. We agree that this is not enjoyable and that you have inquiries. Hearing such a sound is not always a good sign, but it may also be nothing serious. To assist you solve this issue, our team has chosen to write this content page to assist you in this research. First, we will describe how the starter motor works on your Subaru Crosstrek, and then what starter motor noises you can notice on your Subaru Crosstrek.
Functioning and various information
Function of a starter motor on Subaru Crosstrek
The starter motor is an electric motor whose sole job is to start the engine of your car. By a magnetic system and a “serial” technology, it will release an enormous torque that will allow it to drive the pistons of the engine that are subjected to enormous compression and an oil that provides additional resistance being not very fluid when cold.
It is completed by the “solenoid”. It is an electromagnet that goes under a 12 volt electric impulse to push the fork (link part between the “solenoid” and the electric motor of the starter) and thus engage the starter drive pinion on the engine flywheel. Following this action, once in engagement, the starter motor of your Subaru Crosstrek is activated and turns the drive pinion on the flywheel to start the engine.
How to avoid starter motor noises on Subaru Crosstrek
- Do not try to start your engine for too long
- Do not use a starter motor on Subaru Crosstrek with a tired battery
Even if your engine does not start because of tired glow plugs, for example, or because the climate is too cold. You should not turn your key for more than a few seconds or you will burn it.
Although when you have a battery that is exhausted, you always want to start your car, the energy it is capable of holding may not be sufficient to give the power expected by the starter motor to start your engine. Repeated attempts will pre-use your starter motor and if you do not deal with the origin of your failure to start repeatedly, your starter may be the future component you will have to swap.
I acknowledge noises from the starter motor of my Subaru Crosstrek, what are the causes?
I encounter a loud noise from the starter of my Subaru Crosstrek
If you listen to a starter motor noise on Subaru Crosstrek and you have the feeling that it is approaching a loud noise, it is conceivable that it is the starter motor gears that are at the origin of it. Indeed, often when the part has been dismantled for other fixes, its adjustment in relation to the engine flywheel may no longer be appropriate, in which case the gears will be worn down after some time and will not slip and will no longer properly engage the engine when starting. Examine the state of the drive pinion, if it is responsible of the starter motor noise on your Subaru Crosstrek swap it.
If it is a noise in the front of your car but it seems to you after examining not to come from your starter, read this content page about front end noise on Subaru Crosstrek which may give you other leads to remedy your noise issue.
I acknowledge a clicking noise of the key running in my neiman but no noise at the starter motor of my Subaru Crosstrek
If you acknowledge a clicking noise at the starter motor of your Subaru Crosstrek, there are two possible failures connected to this warning sign. If you have in addition to the noise the motor is not running, it may be the “solenoid” is not supplied with energy. One of the most common ways to relaunch it is to hit it with a metal bar to remove the dust that blocks it. If that is not enough, it may be the neiman who is concerned. You could have a issue with unplugged cable verify your electrical installation. If after examining this clicking noise on Subaru Crosstrek doesn’t come from your starter motor, check this article for more informations.
