You listen to a starter motor noise on your Fiat Bravo 2 once you start your automobile. We agree that this is not agreeable and that you have questions. Listening such a noise is not always a good signal, but it may also be nothing major. To assist you resolve this issue, our team has decided to produce this content page to help you in this research. First, we will detail how the starter motor works on your Fiat Bravo 2, and then what starter motor noises you can discover on your Fiat Bravo 2.
Functioning and various information
Function of a starter motor on Fiat Bravo 2
The starter motor is an electric motor whose single task is to start the engine motor of your vehicle. By a magnetic system and a “serial” technology, it will generate an enormous torque that will allow it to drive the pistons of the engine that are subjected to enormous compression and an oil that provides additional resistance being not very fluid when cold.
It is completed by the “solenoid”. It is an electromagnet that goes under a 12 volt electric impulse to push the fork (link element between the “solenoid” and the electric motor of the starter) and thus engage the starter drive pinion on the engine flywheel. Following this action, once in engagement, the starter motor of your Fiat Bravo 2 is activated and turns the drive pinion on the flywheel to start the engine.
How to prevent starter motor noises on Fiat Bravo 2
- Do not run your starter too long
- Do not use a starter motor on Fiat Bravo 2 with a tired battery
Even if your engine does not start because of tired glow plugs, for example, or because the climate is too cold. You should not try to start for more than a few seconds or you will burn your starter motor.
Although when you have a battery that is exhausted, you always want to start your vehicle, the energy it is capable of holding may not be enough to generate the power needed by the starter motor to start your engine motor. Repeated attempts will pre-use your starter motor and if you do not resolve the reason of your failure to start repeatedly, your starter may be the future element you will have to replace.
I listen to noises from the starter motor of my Fiat Bravo 2, what are the causes?
I encounter a loud noise from the starter of my Fiat Bravo 2
If you listen a starter motor noise on Fiat Bravo 2 and you have the feeling that it is close to a loud noise, it is plausible that it is the starter motor gears that are at the source of it. In fact, often when the part has been dismantled for other fixes, its adjustment in relation to the engine flywheel may no longer be ideal, in which situation the gears will be worn down over time and will not slip and will no longer properly activate the engine when starting. Verify the condition of the drive pinion, if it is responsible of the starter motor noise on your Fiat Bravo 2 replace it.
If it is a noise in the front of your vehicle but it seems to you after examining not to come from your starter, read this content page about front end noise on Fiat Bravo 2 which may offer you other leads to remedy your noise issue.
I listen to a clicking noise of the key running in my neiman but no noise at the starter motor of my Fiat Bravo 2
If you listen to a clicking noise at the starter motor of your Fiat Bravo 2, there are two possible failures related to this warning sign. If you have in addition to the noise the motor is not running, it may be the “solenoid” is not supplied with energy. One of the most traditional ways to relaunch it is to hit it with a metal bar to remove the dust that blocks it. If that is not enough, it may be the neiman who is concerned. You might have a issue with unplugged cable verify your electrical installation. If after checking out this clicking noise on Fiat Bravo 2 doesn’t come from your starter motor, check this article for more informations.
